B. Rotor Dish Configuration
I will provide you with an example to demonstrate how this
should be done. This example will be for 2 LNBs, one linear
standard and one circular, connected to a 22 kHz switch tuning
satellites at 82, 91, 110, 119, 148, 97, 105, and 121 degrees.
Equipment:
1. 30 inch or larger dish with a circular LNB for R and L
polarization and linear standard LNB for H and V
polarization. A universal linear LNB will not work with the
22 kHz switch.
2. 22 kHz switch. (A DiSEqC switch will also work but a
simple on and off switch such as a 22 kHz switch will work
just as well.)
3. Rotor. I recommend the Stab HH series. Some of the
others lose position memory. The Stab HH rotor also can
be setup easier using the Gotoxx protocol. I will add
this in future Newbies.
Procedure:
1. Mount the dish and make sure everything is level and
plumb.
2. Install the linear LNB in the center of the dish.
3. Install the circular LNB just to the left of the linear LNB as
you are looking at the front of the dish.
4. Connect the circular LNB to the OFF pole of the switch and
the linear LNB to the ON pole of the switch.
Commentaires sur ces manuels